The MPLS WG Archive

[abhay <abhay@multitech.co.in>]

Lenoid,

       The TE-MIB at the head end which originates contains the configuration for the tunnel.

       At the transit and the tail ends it contains entries made by the signaling protocol,

       which may be RSVP/CR-LDP.

       Additionally each LSP can be identified by the XC Groups in the LSR MIB and there is a one

       to many XC Group relation from the tunnel entry in the TE-MIB to the LSP in the LSR MIB.

       Transit routers may contain entries made by the signaling protocol in the mplsTunnel Table

       ,if they have the ability to do so..as RSVP and CR-LDP have their own capabilities and pitfalls.

       But we can have an effective LSP control if we have entires in the transit routers,if you are interested

       in complete traffic engineering.

       Regards,

       Abhay

Leonid Dubinsky wrote:

> Hi,
> I've read the drafts LSR MIB and TE-MIB, but I was unable to figure
> out
> from them where transit LSR should store information about LSPs passing
> through it. Should it be placed in mplsTunnelTable?
> Anyone has any thoughts on this?
> Best Regards,
>     Leonid Dubinsky.