The MPLS-OPS Archive

[Robert Raszuk <raszuk@cisco.com>]

The application where ldp under vrf is needed is Carrier's Carrier.

R.

> Mark Lewis wrote:
> 
> Felix,
> 
> I must admit, I am a bit confused as to why you would want to run LDP out of
> a vrf i/f. Not sure if the following will even work for a vrf i/f, but:
> 
> To change the address used for the ldp session, you can use the following
> commands:
> 
> set protocols ldp transport-address [i/f or loopback]
> this sets the address globally
> 
> or
> 
> set protocols ldp interface {i/f name} transport-address [i/f or loopback]
> for a particular i/f
> 
> Hope that helps,
> 
> Mark
> 
> >From: felix d <feldz7@yahoo.com>
> >To: mpls-ops@mplsrc.com
> >Subject: ldp with customer on juniper m20
> >Date: Tue, 27 Nov 2001 07:36:13 -0800 (PST)
> >
> >hi all,
> >
> >i like to know if it is possible to run ldp on a vrf
> >interface on a Juniper.
> >
> >right now ldp tries to setup adjacency with its own
> >loopback which is in the global routing table (and
> >which the customer end router cannot reach)
> >
> >i can do the same thing on a cisco 7200vxr.
> >
> >thanks in advance,
> >
> >felix.
> >
> >__________________________________________________
> >Do You Yahoo!?
> >Yahoo! GeoCities - quick and easy web site hosting, just $8.95/month.
> >http://geocities.yahoo.com/ps/info1
> >
> >-------
> >The MPLS-OPS Mailing List
> >Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
> >Archive: http://www.mplsrc.com/mpls-ops_archive.shtml
> 
> _________________________________________________________________
> Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
> 
> -------
> The MPLS-OPS Mailing List
> Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
> Archive: http://www.mplsrc.com/mpls-ops_archive.shtml

-------
The MPLS-OPS Mailing List
Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
Archive: http://www.mplsrc.com/mpls-ops_archive.shtml