RE: Cisco VPN Solution Center

I agree and I shall try that. But in case of full mesh configuration?

Suppose that I already have a VPN configured and a new PE is added with a new costumer site connected. I have to go to all PEs and enter the commands manually.

Does anyone know how Orchestream handles this?

Thanks,

Rui Valente
NPD-DRD Vodafone(Portugal)
Tel: +351210914085
Mob: +351919513001
rui.valente@corp.vodafone.pt

-----Original Message-----
From: Ross Chandler [mailto:ross@eircom.net]
Sent: quarta-feira, 11 de Setembro de 2002 14:17
To: mpls-ops@mplsrc.com
Subject: Re: [MPLS-OPS]: Cisco VPN Solution Center

Hi everyone,

I'm running test on Cisco VPNSC. I was able to properly configure PE and CE configurations for the VPN (vrf, rd, routing protocol PE-CE). What couldn't configure using the VPNSC was MP-IBGP peers between several PEs.

Does anyone know how to do it on the VPNSC? Is it possible to do it on the VPNSC? I'm using version 2.1.

That isn't part of VPNSC's normal operations.

You could try templating it however. It isn't like a PE-CE service request.

If you use route reflectors for the MP-iBGP it will scale better and

the desire to template it will be reduced.

Regards

Ross

This message may contain confidential information or privileged material, and is intended only for the individual(s) named. If you are not in the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system.

E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.

The MPLS-OPS Archive

RE: Cisco VPN Solution Center