The MPLS-OPS Archive
[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index][Thread Index][Author Index][Subject Index]
Re: MPLS TE in Single Area
-
From: Aditya Kaul <aditya.kaul@HotPOP.com>
-
Date: Wed, 25 Aug 2004 21:06:40 +0530
-
Resent-Date: Wed, 25 Aug 2004 12:06:08 -0400
-
To: Ahmad Suzaili Shaari <suzaili@yahoo.com>, mpls-ops <mpls-ops@mplsrc.com>
-
X-HotPOP: ----------------------------------------------- Sent By HotPOP.com FREE Email Get your FREE POP email at www.HotPOP.com -----------------------------------------------
-
X-Sender: aditya.kaul@HotPOP.com @pop.hotpop.com
Right now on cisco you have to specify loosely routed ERO for each
ABR.
On juniper,I dont think you can configure Inter-Area TE LSP.
Hope Cisco/Juniper guys can comment if the above is incorrect.
Rgds
Aditya
draft-ietf-tewg-interarea-mpls-te-req-02.txt
draft-vasseur-mpls-loose-path-reopt-01.txt
draft-kompella-mpls-multiarea-te-03.txt
http://www.cisco.com/en/US/tech/tk436/tk832/tech_brief09186a00801f0b2d.html
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120st/120st19/inter_ar.htm
At 07:59 PM 8/25/2004, Ahmad Suzaili Shaari wrote:
Thank you for your replies and
comments.
A follow-up to that question is about MPLS TE in a single area. I've read
in a few articles that the MPLS Traffic Engineering can only be
configured within a single area. If that is the case then what happen if
a network is segmented into multiple areas, how do you do MPLS TE across
multiple areas.
Thank you.
Do you Yahoo!?
Yahoo! Mail is new and improved -
Check
it out!
| |
|