The MPLS-OPS Archive

[Pankaj Risbood <risbood@research.bell-labs.com>]

Way to configure load balancing on Juniper.

On Thu, 26 Aug 2004, Clark, Anthony wrote:

> routing-options {
>     router-id 192.168.0.2;
>     autonomous-system 5650;
>     forwarding-table {
>         export LB;
>     }
>
> }
> policy-options {
>     policy-statement LB {
>         then {
>             load-balance per-packet;
>         }
>     }
>
> -----Original Message-----
> From: Clark, Anthony
> Sent: Thursday, August 26, 2004 8:40 AM
> To: Peters, John
> Subject: FW: [MPLS-OPS]: Load sharing across LSPs on Juniper hardware
>
> -----Original Message-----
> From: Palmer, Rob A [mailto:Rob.Palmer@team.telstra.com]
> Sent: Wednesday, August 25, 2004 11:03 PM
> To: mpls-ops@mplsrc.com
> Subject: [MPLS-OPS]: Load sharing across LSPs on Juniper hardware
>
>
>
> Does anyone know how to configure a Juniper router to do per-prefix load balancing across LSPS between the same source and destination? I have tried reading the documentation but it is very un-enlightening.
> Some example config would be helpful.
>
> thanks,
> Rob
>
> -------
> The MPLS-OPS Mailing List
> Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
> Archive: http://www.mplsrc.com/mpls-ops_archive.shtml
>
> -------
> The MPLS-OPS Mailing List
> Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
> Archive: http://www.mplsrc.com/mpls-ops_archive.shtml
>

-------
The MPLS-OPS Mailing List
Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
Archive: http://www.mplsrc.com/mpls-ops_archive.shtml