The MPLS-OPS Archive
[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index][Thread Index][Author Index][Subject Index]
RE: MPLS TE in Single Area
-
From: Aditya Kaul <aditya.kaul@HotPOP.com>
-
Date: Thu, 26 Aug 2004 19:55:36 +0530
-
Resent-Date: Thu, 26 Aug 2004 11:13:22 -0400
-
To: <jerome.law@bt.com>, <suzaili@yahoo.com>, <mpls-ops@mplsrc.com>
-
X-HotPOP: ----------------------------------------------- Sent By HotPOP.com FREE Email Get your FREE POP email at www.HotPOP.com -----------------------------------------------
-
X-Sender: aditya.kaul@HotPOP.com@pop.hotpop.com
None so far !!!
At 02:50 PM 8/26/2004, jerome.law@bt.com wrote:
I
think this works out fine in theory but how many providers out there do
you know that have done this?
- -----Original Message-----
- From: Aditya Kaul
[mailto:aditya.kaul@HotPOP.com]
- Sent: 25 August 2004 16:37
- To: Ahmad Suzaili Shaari; mpls-ops
- Subject: Re: [MPLS-OPS]: MPLS TE in Single Area
- Right now on cisco you have to specify loosely routed ERO for each
ABR.
- On juniper,I dont think you can configure Inter-Area TE
LSP.
- Hope Cisco/Juniper guys can comment if the above is
incorrect.
- Rgds
- Aditya
- draft-ietf-tewg-interarea-mpls-te-req-02.txt
- draft-vasseur-mpls-loose-path-reopt-01.txt
- draft-kompella-mpls-multiarea-te-03.txt
- http://www.cisco.com/en/US/tech/tk436/tk832/tech_brief09186a00801f0b2d.html
- http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120st/120st19/inter_ar.htm
- At 07:59 PM 8/25/2004, Ahmad Suzaili Shaari wrote:
- Thank you for your replies and comments.
-
- A follow-up to that question is about MPLS TE in a single area. I've
read in a few articles that the MPLS Traffic Engineering can only be
configured within a single area. If that is the case then what happen if
a network is segmented into multiple areas, how do you do MPLS TE across
multiple areas.
-
- Thank you.
- Do you Yahoo!?
- Yahoo! Mail is new and improved -
Check
it out!
| |
|