The MPLS-OPS Archive

["Hernan Hevia" <hhevia@ntzn.com>]

Jeff,

 

I'm thinking of starting with a simple LSP in the Juniper network, then I'll try to go RFC2547.

Any practical example on how to do that? What should I be aware of if I configure MPLS on a Juniper that is already in service with BGP, a couple of routing instances, etc? I don't want to jeopardize inet.0 configuring MPLS.

Thank you very much in advance.

 

Regards

Hernán

-----Original Message-----
From: Richmond, Jeff (ELI) [mailto:jeff_richmond@eli.net]
Sent: Thursday, October 14, 2004 11:17 AM
To: Hernan Hevia; mpls-ops@mplsrc.com
Subject: RE: [MPLS-OPS]: Juniper MPLS

Hernán,

 

There are a number of ways to deploy MPLS, so you'll probably want to narrow your focus down a bit. What exactly are you trying to accomplish? If it is just setting up an LSP from point A to point Z, well, that is pretty simple. If you are wanting to setup 2547 VPNs, that isn't difficult either, but requires a bit more work and understanding of MPLS and BGP, for example.

 

Regards,

-Jeff 

-----Original Message-----
From: Hernan Hevia [mailto:hhevia@ntzn.com]
Sent: Thursday, October 14, 2004 6:12 AM
To: mpls-ops@mplsrc.com
Subject: [MPLS-OPS]: Juniper MPLS

Hi,

 

I'm about to start working on an MPLS project using Juniper routers.

Could anyone provide good literature with examples, tips and tricks, etc, besides what is included in Junos documentation?

Thanks in advance!

 

Hernán