The MPLS-OPS Archive

["Alok" <alokdube@hotpop.com>]

Hi,

Let me clarify my question,

I am saying I have a link in between node A and B.

All I care about is sending data between A and B.

All my circuits are signalled. Not PVCs, RSVP LSPs signalled from say CPEs.

Why should on not advertise aggregate bandwidth of the link so that CSPF can
look at the whole picture of the link and decide how to setup the LSPs ?

-thanks
Alok
----- Original Message ----- 
From: "Khan, Amjad" <akhan@flagtelecom.com>
To: "'Alok'" <alokdube@hotpop.com>
Sent: Thursday, February 24, 2005 3:53 PM
Subject: RE: [MPLS-OPS]: a question


> Alok,
> Each Vc has a separate IP addressing? If so, then each VC will have a
> separate end-to-end LSP. So you can't bundle them.
>
> Regards,
> Amjad
>
> -----Original Message-----
> From: Alok [mailto:alokdube@hotpop.com]
> Sent: 24 February 2005 13:47
> To: mpls-ops@mplsrc.com
> Subject: [MPLS-OPS]: a question
>
> Hi,
>
>
> I have a link between 2 nodes A and B.
> The link can be further split into 10 different sub component links, vcs
but
> they are between the same nodes.
>
> For CSPF computation, does it serve a purpose to advertise each of these
> links individually rather than a bundle?
>
> finally the capacity between 2 links is limited by the baud rate of the
> wire. So why are they individually advertised?
>
> -thanks
> Alok
>
>
> -------
> The MPLS-OPS Mailing List
> Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
> Archive: http://www.mplsrc.com/mpls-ops_archive.shtml
>
>
> **********************************************************************
> This e-mail message is confidential and is intended only for the use of
the
> individual or entity named above and contains information which is or may
be
> confidential, non-public or legally privileged. Any dissemination or
> distribution of this message other than to its intended recipient is
> strictly prohibited. You should not copy it or use it for any purpose nor
disclose
> the contents to any other person. If you have received this message in
error, please
> notify us by email to postmaster@flagtelecom.com immediately and delete
the
> original message and all copies from all locations in your computer
systems.
>
>
> This e-mail has been swept by Mailsweeper TM for viruses. However, FLAG
> Telecom cannot accept liability for any damage which you may sustain as a
> result of software viruses.
> **********************************************************************
>
>
>
>
>
> This message has been scanned for viruses by MailControl -
www.mailcontrol.com


-------
The MPLS-OPS Mailing List
Subscribe/Unsubscribe:  http://www.mplsrc.com/mplsops.shtml
Archive: http://www.mplsrc.com/mpls-ops_archive.shtml